Products
Power Amplifiers 0.5-110 GHz up to 200 W
Focus Microwaves' solid-state power amplifiers provide the drive and injection power required for load-pull, ruggedness, and device characterization test benches. Our amplifier portfolio covers frequencies from 0.5 GHz to 110 GHz, delivering output power from 2 W at W-band up to 200 W. Available with coaxial or waveguide interfaces, these amplifiers integrate seamlessly with Focus tuners, couplers, and test fixtures.
Features & Benefits
Where the amplifier sits in a load pull setup
Driving the device into compression
Between the signal source and the device, couplers, bias tees, the source tuner and the fixture all take their share of the drive signal. A driver amplifier restores that power, so the transistor reaches saturation, even while the source tuner presents a strong mismatch.
Injection for active and hybrid load pull
On the load side, the amplifier injects an amplitude and phase-controlled signal back toward the device, synthesizing reflection magnitudes a passive tuner cannot reach at the device plane. Pre-matching with a passive tuner cuts the injection power required, so a smaller amplifier covers the same impedances.
Millimeter-wave and W-band benches
Cable, probe and tuner losses climb quickly above 40 GHz. The 40–67 GHz and 75–110 GHz models, with 1.85 mm and WR10 interfaces, bring usable power to the probe tip for on-wafer power sweeps and load pull at millimeter-wave frequencies.
Model List Table
Request a Quote
Please use this form to request a quote.
"*" indicates required fields