News

ABSTRACT A high speed tuning and measuring algorithm is used for production level testing on-wafer a large number of chips. It applies to a hybrid active injection load pull test system. Using a pre-calibration of the passive tuner and the amplitude and phase settings of the active power injection signal

ABSTRACT Impedance tuners used in high power measurements suffer fast heating and consequently thermal expansion of the center conductor, which has a very small mass and is thermally isolated from the environment and tuner housing. This leads to false measurements or catastrophic tuner failure (short) of either the DUT or

ABSTRACT Improved interdigital parallel plate rotary capacitors to be used in automatic MHz range tuners have a grounding technique based on bronze sliding contact to effectively and continuously lead to the ground terminal the rotating comb-like blades of the capacitor and (optional) damping resistors inserted between the sliding contact and

ABSTRACT A compact device allows individual or combined correction of wafer probe planarity and orientation misalignment. The device is made as a metallic block or as a strong plastic block and contains three sections, which are held together by a steel blade or by a steel blade and a rotation

ABSTRACT An impedance synthesis method for single and multi-probe high resolution slide screw impedance RF and microwave tuners employs a fast calibration algorithm, which creates appropriately distributed calibration points over the Smith chart and a second order interpolation algorithm between calibration points, optimized for best suitability to the natural behavior

ABSTRACT An automated “double-decker” slide screw impedance tuner uses two tuning probes, independently movable inside two stacked circular slablines, which lie flat on the bench table. The eccentrically self-rotating disc probes are mounted at the end of rotating radial arm-carriages, the total mechanism operating in a planetary configuration. The radial

ABSTRACT A multi-band, electro-mechanical programmable impedance tuner for the frequency range between 10 and 200 MHz uses cascades of three or more continuously variable mechanical capacitors interconnected with sets of low loss flexible or semi-rigid cables; for each frequency band a different set of cables and capacitors are used. The

ABSTRACT // 14,751,544 A new slide screw impedance tuner structure uses a circular slabline, eccentrically rotating disc probes and a rotating carriage allowing reducing the linear size of the tuner by a factor of 3. The slabline lies flat on the bench table surface and the disc probe rotates at

ABSTRACT An adapter alignment device, that can be added on the coaxial RF connectors of instruments,   especially slide screw impedance tuners, aligns and guides precisely and repeat ably the male and female adapters into each-other. This leaves the internal center conductors of the tuner slabline,   which are attached to the

ABSTRACT Fast tuning and measuring algorithms in open loop active load pull systems have been developed to accommodate high speed production testing of many chips of the same kind on wafer; they are based on re-setting the (pre-calibrated) amplitude and phase of the injected power into the device output port.

ABSTRACT A noise parameter test setup allows accurately measuring the four noise parameters (Fmin, Rn, Γopt) of microwave transistors over a wide frequency range using two wide-band directional couplers, instead of SPDT switches, to merge the s-parameter (signal) measurement path and the noise measurement path, avoiding thus the uncertainty of

ABSTRACT A wideband four noise parameter extraction method uses randomly distributed source states; the data are collected using wideband electro-mechanical tuners and noise and small signal receivers (network analyzers) in fast frequency sweeps; because of the random nature of source impedances reliable noise parameter values are extracted using selected source